Put the bobbin onto the bobbin winder shaft and slide the bobbin winder shaft to the right. Make sure that the thread is pulled as far as possible into the pre-tension disk, otherwise the bobbin may not be wound cleanly.Ĥ.
When sewing with fine, cross-wound thread, use the small spool cap, and leave a small space between the cap and the spool.ģ. Perform the same operation to change the setting so that machine beeps. This setting can be changed so that the machine does not beep. When the sewing machine is purchased, it is set to beep each time a key is pressed. Perform the same operation to change the initial needle position to the left needle position. The specified initial needle position is maintained after the machine is turned off. The initial needle position can be changed to the straight stitch (center needle position). Normally, the straight stitch (left needle position) is automatically selected when the sewing machine is turned on. Perform the same operation to change the needle stop position to the lowered position. Instead, the machine can be set to leave the needle raised when sewing is stopped. Normally, the sewing machine is set to leave the needle in the fabric when sewing is stopped. Slide the sewing speed controller to select the desired sewing speed. Sewing speed controller (for models equipped with the start/ stop button) When the foot controller is plugged in, the start/ stop button cannot be used to start sewing (only for models equipped with the start/stop button). 
Doing so could cause a fire or an electric shock. Do not allow pieces of cloth and dust to build up on the foot controller.You should make sure that nothing is placed on the foot controller when the machine is not in use. When connecting the foot controller, be sure to turn off the sewing machine in order to prevent the machine from accidentally being started.ĭepress the foot controller to start sewing, and adjust the sewing speed by changing the pressing force.Insert the foot controller plug into its jack/socket.
#Brother project runway sewing machine manual install
If it still does not fit, contact a qualified electrician to install the proper outlet. If the plug does not fit fully in the outlet, reverse the plug. To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. This appliance has a polarized plug (one blade wider than the other). If a power outage occurs while the sewing machine is being operated, turn off the sewing machine and unplug the power supply cord. The sewing light goes off when the machine is turned off. To turn off the machine, set the main power switch to “O”. When the machine is turned on, the needle and the feed dogs will make sound when they move this is not a malfunction.ģ. Push the spool pin down until it locks into place. The operation buttons differ depending on the sewing machine model.Ģ. The needle plate is marked with guides for sewing straight seams. You can start sewing without pulling up the bobbin thread. Quick-set bobbin (for models equipped with the quickset bobbin). The feed dogs feed the fabric in the sewing direction. Use when removing the needle plate cover. Attach the appropriate presser foot for the selected stitching. 
The presser foot applies pressure consistently on the fabric as the sewing takes place.Use the presser foot holder screw to hold the presser foot holder in place.The presser foot is installed onto the presser foot holder.Needle threader (for models equipped with the needle threader).
0 kommentar(er)
